Construction:
Fixture Housing - One piece unitized precise heavy
wall cast aluminum construction comprised of low
copper (< 0.2% Cu) aluminum. Hood is fastened to the
Housing with a stainless steel hinge and secured with a
tool-less stainless steel latch 180° opposite the hinge.
Housing and Hood is sealed with an extruded closed cell
silicone gasket.
HID Electrical Module - All electrical components are UL
and cUL recognized are mounted on a single plate and
factory prewired with quick-disconnect plugs. Standard
electronic MH ballasts have power factor of >.95 (70W –
150W) -20°F starting, 120-277V or >.90 (250W), -20°F
starting, 200-277V, 50Hz/60Hz and have lamp End-of-life
protection. 347V option utilizes a step down transformer to the electronic ballast. Electronic MH ballast has a power factor of >.90 (210W), -4°F starting, 200 - 277V, 50Hz/60Hz and has lamp End-of-life protection. Magnetic MH ballasts are high power factor (70W – 150W) or CWA (250W), -20°F starting, multi-tap 120-277V, 60Hz. All HPS
ballasts are core and coil, high-reactance, high power
factor (70W – 150W) or CWA (200W – 250W), -40°F
starting.
LED Power Array Driver - UL and CUL recognized Constant Current LED drivers operate on input voltages from 120 – 277VAC,
50/60hz and are mounted to an aluminum bracket
secured to the barrier plate. Terminal blocks facilitate wiring between the driver and optical arrays, and between driver and incoming supply. Driver is independently sealed and UL Listed for wet location.
Consult Factory for High-Low and dimming options
VLED Driver – Driver is UL and cUL recognized mounted on a
single plate and factory prewired with quick-disconnect
plugs. Constant current driver is electronic and has a
power factor of >.90 and a minimum operating
temperature of -40°F. Drivers accept an input of
120-277V, 50/60Hz. Consult factory for dimming applications.
Finish - Electrostatically applied TGIC Polyester Powder
Coat on substrate prepared with 20 PSI power wash at
140°F. Four step sand blast and iron phosphate
pretreatment for protection and paint adhesion. 400°F
bake for maximum hardness and durability. Texture finish is standard. |