Fixture Housing - Durable corrosion resistant low copper cast aluminum alloy A356 (<0.2% Cu) having a minimum wall thickness of ¼”. Body secures to Mounting Stanchion by means of a cast aluminum wedge lock secured by a single stainless steel bolt and accessed through the access panel.
Top Cover - Durable corrosion resistant low copper cast aluminum alloy A356 (<0.2% Cu) having a minimum wall thickness of ¼”. Top is crowned for water run off, and retainer screw cavities are open for drainage. Top is fully gasketed and secured by (4) stainless steel allen screws.
Access Panel(s) - Durable corrosion resistant low copper cast aluminum alloy A356 (<0.2% Cu) having a minimum wall thickness of ¼”. Panel(s) is fully gasketed and retained by (2) stainless steel allen screws located below the lens.
Lens - Tempered Micro-Prism glass, fully gasketed, and retained by aluminum clips.
HID Electrical Module - All electrical components are UL recognized. Electronic MH ballasts are high power factor, -20F starting, 120-277V, 50Hz/60Hz. 347V option utilizes a step down transformer to the electronic ballast. Magnetic MH ballasts are high power factor, -20F starting, multi-tap 120-277V, 60Hz. All HPS ballasts are core and coil, reactor-style, high power factor, -40F starting,120V. Compact Fluorescent ballast is electronic, 120-277V, 50Hz/60Hz. Electrical components are mounted to a unitized ballast tray inside the body, and factory installed. Ballast assembly connects to reflector assembly via quick disconnects. (Consult factory for LED electrical specifications).
VLED Driver – Driver is UL and cUL recognized mounted on a
single plate and factory prewired with quick-disconnect
plugs. Constant current driver is electronic and has a
power factor of >.90 and a minimum operating
temperature of -40°F. Drivers accept an input of
120-277V, 50/60Hz. Consult factory for dimming applications.
Mounting Stanchion - 3½” SCH40 steel pipe (below grade) welded to 3” SCH 40 steel pipe (above grade). (4) sections of reinforcing bar welded to lower pipe for tie-in to paving and footing steel by others. Entire assembly is hot dipped galvanized.
Finish - Electrostatically applied TGIC Polyester Powder
Coat on substrate prepared with 20 PSI power wash at
140°F. Four step sand blast and iron phosphate
pretreatment for protection and paint adhesion. 400°F
bake for maximum hardness and durability. Texture finish is standard.